{"id":10504,"date":"2020-10-20T08:00:00","date_gmt":"2020-10-20T14:00:00","guid":{"rendered":"http:\/\/pimpmyboardgame.com\/?p=10504"},"modified":"2020-10-18T14:17:04","modified_gmt":"2020-10-18T20:17:04","slug":"reboarding","status":"publish","type":"post","link":"http:\/\/pimpmyboardgame.com\/?p=10504","title":{"rendered":"Reboarding"},"content":{"rendered":"\n<p class=\"wp-block-paragraph\">With Tentfinity being successful over the past month+, I decided to make the set up a bit easier by making a new 4&#8242; x 4&#8242; board.  Previously, I&#8217;ve been relying on a double set of 4&#215;4 sheetrock panels but they are annoyingly heavy to move.  The panels are also fragile without good support, susceptible to moisture if it starts to rain with wind picking up, and I tend to get dirty carting them around. <\/p>\n\n\n\n<figure class=\"wp-block-image size-large\"><img loading=\"lazy\" decoding=\"async\" width=\"600\" height=\"600\" src=\"http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_board_0581-600x600.jpg\" alt=\"\" class=\"wp-image-10472\" srcset=\"http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_board_0581-600x600.jpg 600w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_board_0581-400x400.jpg 400w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_board_0581-198x198.jpg 198w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_board_0581-768x768.jpg 768w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_board_0581-1536x1536.jpg 1536w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_board_0581-2048x2048.jpg 2048w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_board_0581-88x88.jpg 88w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_board_0581-900x900.jpg 900w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_board_0581-1280x1280.jpg 1280w\" sizes=\"auto, (max-width: 600px) 100vw, 600px\" \/><\/figure>\n\n\n\n<!--more-->\n\n\n\n<p class=\"wp-block-paragraph\">I picked up two 4&#8242; x 2&#8242; pressboard pieces and enough 1&#8243; x 2&#8243; pine pieces to run rails around the board flats.  This created a sturdy and light table easily handled for the back and forth outdoor setup we need each week.<\/p>\n\n\n\n<figure class=\"wp-block-image size-large\"><img loading=\"lazy\" decoding=\"async\" width=\"600\" height=\"400\" src=\"http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_N4_game_201017_1518-600x400.jpg\" alt=\"\" class=\"wp-image-10473\" srcset=\"http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_N4_game_201017_1518-600x400.jpg 600w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_N4_game_201017_1518-400x267.jpg 400w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_N4_game_201017_1518-198x132.jpg 198w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_N4_game_201017_1518-768x512.jpg 768w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_N4_game_201017_1518-900x600.jpg 900w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_N4_game_201017_1518.jpg 1200w\" sizes=\"auto, (max-width: 600px) 100vw, 600px\" \/><\/figure>\n\n\n\n<p class=\"wp-block-paragraph\">I still have the board maps straddled over two regular tables but they are sturdy enough to allow for more room on the edges. A set of clamps secure the two boards together and I&#8217;ll likely switch this to a bolt+wingnut system a little later.<\/p>\n\n\n\n<figure class=\"wp-block-image size-large\"><img loading=\"lazy\" decoding=\"async\" width=\"600\" height=\"338\" src=\"http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/254-neon-lotus-shaping-the-infinity-universe-1-600x338.jpg\" alt=\"\" class=\"wp-image-10505\" srcset=\"http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/254-neon-lotus-shaping-the-infinity-universe-1-600x338.jpg 600w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/254-neon-lotus-shaping-the-infinity-universe-1-400x225.jpg 400w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/254-neon-lotus-shaping-the-infinity-universe-1-198x111.jpg 198w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/254-neon-lotus-shaping-the-infinity-universe-1.jpg 686w\" sizes=\"auto, (max-width: 600px) 100vw, 600px\" \/><\/figure>\n\n\n\n<p class=\"wp-block-paragraph\">Another improvement was adhering the paper play mat to the boards.  I was using blutac to secure the mats down to the sheetrock but it didn&#8217;t always work and it had to be redone each time we played.  I picked up extras of the old Red Veil scenery pack to eventually make a full 4&#8242; x 4&#8242; board. <\/p>\n\n\n\n<p class=\"wp-block-paragraph\">With the large boards, spray adhesive was used to mount the paper mats to the panels.  Technically, each paper mat is 24&#8243; x 32&#8243;. This meant I&#8217;d need to cannibalize one of the maps to shore up the final 16&#8243; to bring each panel to 48&#8243; long.  After opening up the packs, I saw that the mats vary widely in sizes with one set being 25&#8243; x 33&#8243; and others being 23&#8243; x 30&#8243;. The results meant that the cuts and layouts didn&#8217;t really match up.  Couple that with the innate challenge of working with a large paper mat and a spray adhesive board, and the whole thing went a little sideways.<\/p>\n\n\n\n<p class=\"wp-block-paragraph\">Eventually, I figured out a technique to lay the paper down without causing bubbles or tears and while it could have looked a lot better, the overall effect is still good.<\/p>\n\n\n\n<figure class=\"wp-block-image size-large\"><img loading=\"lazy\" decoding=\"async\" width=\"600\" height=\"400\" src=\"http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_N4_game_201017_1546-600x400.jpg\" alt=\"\" class=\"wp-image-10501\" srcset=\"http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_N4_game_201017_1546-600x400.jpg 600w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_N4_game_201017_1546-400x267.jpg 400w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_N4_game_201017_1546-198x132.jpg 198w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_N4_game_201017_1546-768x512.jpg 768w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_N4_game_201017_1546-900x600.jpg 900w, http:\/\/pimpmyboardgame.com\/wp-content\/uploads\/2020\/10\/Infinity_N4_game_201017_1546.jpg 1200w\" sizes=\"auto, (max-width: 600px) 100vw, 600px\" \/><\/figure>\n\n\n\n<p class=\"wp-block-paragraph\">We had our first game on the map over the weekend and it worked well. The wind started picking halfway through the game but the mounted map and blutac&#8217;d terrain pieces held firm without any issue.  It was able to stand up to some 5-10 mph gusts so I&#8217;m very happy and look forward to using them as long as the weather holds.<\/p>\n","protected":false},"excerpt":{"rendered":"<p>With Tentfinity being successful over the past month+, I decided to make the set up a bit easier by making a new 4&#8242; x 4&#8242; board. Previously, I&#8217;ve been relying on a double set of 4&#215;4 sheetrock panels but they are annoyingly heavy to move. The panels are also fragile without good support, susceptible to [&hellip;]<\/p>\n","protected":false},"author":1,"featured_media":0,"comment_status":"open","ping_status":"open","sticky":false,"template":"","format":"standard","meta":{"footnotes":""},"categories":[783],"tags":[732,784,105],"class_list":["post-10504","post","type-post","status-publish","format-standard","hentry","category-infinity","tag-board","tag-infinity","tag-paper-terrain"],"_links":{"self":[{"href":"http:\/\/pimpmyboardgame.com\/index.php?rest_route=\/wp\/v2\/posts\/10504","targetHints":{"allow":["GET"]}}],"collection":[{"href":"http:\/\/pimpmyboardgame.com\/index.php?rest_route=\/wp\/v2\/posts"}],"about":[{"href":"http:\/\/pimpmyboardgame.com\/index.php?rest_route=\/wp\/v2\/types\/post"}],"author":[{"embeddable":true,"href":"http:\/\/pimpmyboardgame.com\/index.php?rest_route=\/wp\/v2\/users\/1"}],"replies":[{"embeddable":true,"href":"http:\/\/pimpmyboardgame.com\/index.php?rest_route=%2Fwp%2Fv2%2Fcomments&post=10504"}],"version-history":[{"count":1,"href":"http:\/\/pimpmyboardgame.com\/index.php?rest_route=\/wp\/v2\/posts\/10504\/revisions"}],"predecessor-version":[{"id":10506,"href":"http:\/\/pimpmyboardgame.com\/index.php?rest_route=\/wp\/v2\/posts\/10504\/revisions\/10506"}],"wp:attachment":[{"href":"http:\/\/pimpmyboardgame.com\/index.php?rest_route=%2Fwp%2Fv2%2Fmedia&parent=10504"}],"wp:term":[{"taxonomy":"category","embeddable":true,"href":"http:\/\/pimpmyboardgame.com\/index.php?rest_route=%2Fwp%2Fv2%2Fcategories&post=10504"},{"taxonomy":"post_tag","embeddable":true,"href":"http:\/\/pimpmyboardgame.com\/index.php?rest_route=%2Fwp%2Fv2%2Ftags&post=10504"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}